thomson speedtouch setup - bridged config example/ all models

1. open up your web browser and type in 192.168.1.254 in the address bar at the top and hit enter. this will open up the speedtouch home page (hint: good idea to set your nic card to 192.168.1.xxx and gateway to 192.168.1.254 and use default netmask!)

2. click on the speedtouch menu on the left

3. scroll down to the bottom of the page and click on the set up link

4. a new page will open up. click next

5. select bridge and click next

6. make sure that the vpi/vci is 0.35 for the bell network and 0.33 for telus (your isp can tell you which setting to use)

7. you can either enter in a password here or leave it blank (good idea)and click next

8. if your going to hook your modem to a router: uncheck dhcp server if your going to hook your modem up directly to a computer, keep dhcp server checked click next

9. click on start

10. now we wait...

11. click on finish

12. we are done! enjoy high speed.(you can then set your nic back to dhcp if you changed it as above)